Follow the steps below to print out the wireless network settings for your PIXMA printer, including its IP address and network name.
This printout contains valuable information about your computer. Handle it with care.
Print out the network settings
-
Turn the printer ON.
-
Load a sheet of A4 or Letter-sized plain paper into the tray.
-
Press and hold the Stop button until the Alarm lamp flashes 15 times, then release the button.
A sheet prints with network information similar to what you see below.
Sample printout
| Item | Explanations of the item | Setting |
|---|
| Wireless LAN | Wireless LAN | Enable/Disable |
| Connection | Status of the Wireless LAN | Active/Inactive |
| MAC Address | MAC Address | XX:XX:XX:XX:XX:XX |
| SSID | SSID | SSID (network name) of the wireless LAN |
| Communication Mode | Communication Mode | Infrastructure |
| Channel | Channel | XX (1 to 13) |
| Encryption | Method of the Encryption | none/WEP/TKIP/AES |
| WEP Key Length | WEP Key Length | Inactive/128/64 |
| Authentication | Method of the Authentication | none/auto/open/shared/WPA-PSK/WPA2-PSK |
| Signal Strength | Signal Strength | 0 to 100 [%] |
| TCP/IP Version | TCP/IP Version | IPv4 & IPv6/IPv4 |
| IPv4 IP Address | Selected IP Address (IPv4) | XXX.XXX.XXX.XXX |
| IPv4 Default Gateway | Default Gateway (IPv4) | XXX.XXX.XXX.XXX |
| Subnet Mask | Subnet Mask | XXX.XXX.XXX.XXX |
| IPv6 IP Address *1 | Selected IP Address (IPv6) | XXXX:XXXX:XXXX:XXXX
XXXX:XXXX:XXXX:XXXX |
| IPv6 Default Gateway *1 | Default Gateway (IPv6) | XXXX:XXXX:XXXX:XXXX
XXXX:XXXX:XXXX:XXXX |
| Subnet Prefix Length*1 | Subnet Prefix Length | XXX |
| IPsec*2 | IPsec setting | Active |
| Security Protocol*2 | Method of the Security Protocol | ESP/ESP & AH/AH |
| WPS PIN CODE | WPS PIN code | XXXXXXXX |
| Wireless LAN DRX | Discontinuous reception (wireless LAN) | Enable/Disable |
| Other Settings | Other settings | - |
| Printer Name | Printer name | Printer name (Up to 15 characters) |
| WSD | WSD setting | Enable/Disable |
| WSD Timeout | Timeout | 1/5/10/15/20 [min] |
| LPR Protocol | LPR protocol setting | Enable/Disable |
| Bonjour | Bonjour setting | Enable/Disable |
| Bonjour Service Name | Bonjour service name | Bonjour service name (Up to 52 characters) |
| DNS Server | Getting DNS Server automatically | Auto/Manual |
| Primary Server | Primary server address | XXX.XXX.XXX.XXX |
| Secondary Server | Secondary server address | XXX.XXX.XXX.XXX |
| Proxy Server | Proxy Server setting | Enable/Disable |
| Proxy Port | Specifying Proxy Port | 1 to 65535 |
| Proxy Address | Proxy Address | XXXXXXXXXXXXXXXXXXXX |
| IP Address Filtering | IP Address Filtering | Enable/Disable |
("XX" represents alphanumeric characters.)
*1 The status of the network prints only when IPv6 is activated.
*2 The status of the network prints only when IPv6 and the IPsec settings are activated.
