Loading envelopes in the MP470
Article ID: ART118103 |
| |
Date published: 05/12/2015 |
| |
Date last updated: 08/17/2015 |
Description
Loading envelopes in the MP470
Solution
Set Paper In The rear tray
-
Open the paper support and extend the paper support extension. (See <1> in Figure 1 below.)
-
Open the paper output tray and extension. (See <2> and <3> in Figure 1 below.)
-
Set the paper thickness lever to the right side for envelopes and T-Shirt transfers. (See <4> in Figure 1 below.)
* Figure 1
*MP210 shown
-
Load envelopes in the rear tray with the print side facing up. (See <1> in Figure 3 below.)
-
-
Check the printing direction.
-
Set the envelope in the direction of the arrow as indicated in Figure 2 below.
* Figure 2
-
Align envelopes to the right edge of the . (See <2> in Figure 3 below.)
-
Pinch and slide the paper guide to the envelope's left side. (See <3> in Figure 3 below.)
* Figure 3
Preparing Envelopes to Load:
-
Press down firmly on the edges of the envelopes to make the folds crisp. Also, press firmly on the area that corresponds to the edges of the back flap.
-
Remove any curling by holding the edges diagonally and bending them gently.
-
If the edges of the envelope are inflated or are curling, place the envelope on a flat surface. With a pen, press down while moving it from the center toward the edges of the envelope.
-
Ensure that no curl or puff exceeds 1/8 in. (3 mm).
|
|
|
|
Set paper with the flap closed.
|
Unsuitable Envelopes:
Printer Driver Settings:
Note: It may be required to change the paper size option to 'Envelope' in File Page Setup menu.