This article describes how to configure the printer's IP address on the Control Panel.
- On the Tab Selection screen of the Control Panel, press or to select the Settings/Adj. tab ( ).
| Note | |
If the Tab Selection screen is not displayed, press the Menu button. |
|
- Press the OK button.
The Set./Adj. Menu is displayed.
- Press or to select Interface Setup, and then press the OK button.
- Press or to select TCP/IP, and then press the OK button.
- Press or to select IPv4, and then press the OK button.
- Press or to select IPv4 Settings, and then press the OK button.
- Press or to select IP Address, and then press the OK button.
- After you press or to select the input field, numerical input is possible.
- Press the or button to enter the value.
| Note | |
- Pressing the button increases the number by 1. The maximum value is 9, after which 0 is displayed.
- Pressing the button decreases the number by 1. The minimum value is 0, after which 9 is displayed.
- Hold down or to increase or decrease the value continuously.
- Make sure the IP address you enter for the printer is not the same as any computer IP address in your network.
|
|
- Repeat steps 8 and 9 to complete the settings, and then press the OK button.
- Press the Menu button.
If you have change the settings, a confirmation message is displayed. Press or to select Yes, and then press the OK button.
| Important | |
- Be sure to complete step 11. This will activate the values you have entered.
- You can also specify the subnet mask and default gateway on the Control Panel.
- The DNS can also be configured from the printer Control Panel.
|
|
| Note | |
If an error message is displayed, check the settings and correct any invalid values. |