Setting Dedicated Port and Port Number
This section explains how to set the dedicated port for the printer driver and change the port number for each protocol.
Setting Dedicated Port
To set or browse detailed information on the machine with a Canon printer driver or utility, set <DEDICATED PORT> to <ON>.
The default setting is <ON>.
note:
- If you want to use a Canon printer driver or utility, select <ON> for <USE SNMP> and <DEDICATED PORT>.
- You can restrict the IP addresses of computers on which items can be set or browsed. If you restrict the IP addresses, it is not possible to use the Remote UI to set or browse detailed information on computers other than those whose IP addresses are allowed, even if <USE SNMP> and <DEDICATED PORT> are <ON>.
1. Press 
[Menu].
2. Press 
or 
to select <SYSTEM SETTINGS>, then press [OK].
If the System Manager ID and System Password have been set, enter the System Manager ID and System Password using 
- 
[numeric keys], then press 
[Log In/Out].
3. Press or to select <NETWORK SETTINGS>, then press [OK].
4. Press or to select <DEDICATED PORT>, then press [OK].
5. Press or to select <ON> or <OFF>, then press [OK].
- <ON>: If you want to set or browse detailed information on the machine with a Canon printer driver or utility.
- <OFF>: If you are not using a Canon printer driver or utility.
6. Press 
[Stop/Reset] to return to the standby mode.
7. Turn OFF the main power on the right side of the machine, then turn ON the power to restart the machine.
Setting Port Number
Depending on your network environment, you can change the port number for each protocol.
The default settings are as follows:
- <LPD> : <515>
- <RAW> : <9100>
- <HTTP> : <80>
- <SMTP RX> : <25>
- <POP3 RX> : <110>
- <SMTP TX> : <25>
- <SNMP> : <161>
note:
The default settings are written for D1180.
1. Press [Menu].
2. Press or to select <SYSTEM SETTINGS>, then press [OK].
If the System Manager ID and System Password have been set, enter the System Manager ID and System Password using - [numeric keys], then press 
[Log In/Out].
3. Press or to select <NETWORK SETTINGS>, then press [OK].
4. Press or to select <TCP/IP SETTINGS>, then press [OK].
5. Press or to select <PORT NO.>, then press [OK].
6. Press or to select the protocol of which you want to change the port number (LPD, RAW, HTTP, SMTP RX, POP3 RX, SMTP TX or SNMP), then press [OK].
7. Use - [numeric keys] to enter the port number, then press [OK].
To enter the other port number, repeat step 6 to 7.
note:
After specifying the port number of <SNMP>, <SET IP ADD RANGE> is displayed. If you want to continue setting port numbers, perform the procedures from step 5.
8. Press [Stop/Reset] to return to the standby mode.
9. Turn OFF the main power on the right side of the machine, then turn ON the power to restart the machine.
