Confirm all the packing was removed from inside the machine

Follow the procedure below to confirm all packing was removed from the toner cartridge and from inside the machine.

1. Hold the operation panel.

2. Lift the scanning platform.

If you cannot lift the scanning platform

Ensure that the feeder is completely closed.
Do not try to forcefully lift the scanning platform as this may damage the machine.

*If you set thick documents such as a book, the feeder may not be completely closed. Remove the documents.

3. Hold the grip on the left front side of toner cover.

4.Open the toner cover.

5. Turn the sheet to the back as the figure below.

6. Remove the packing material as the figure below.

7. Remove the toner cartridge.

8. Gently shake the toner cartridge five or six times to evenly distribute the toner.

9. remove the packing material as the figure below.

10. Place the toner cartridge on a flat surface, lift the tab, and gently pull the sealing tape completely out.

The full length of the sealing tape is approximately 20" (50 cm).

11. Remove the packing material as the figure below.

12. Insert the toner cartridge.

Fit the protrusions (A) on each side of the toner cartridge into the guides located on each side of the machine, and then slide the toner cartridge into the machine until the toner cartridge meets the back of the machine.

13. Close the toner cover.

If you cannot close the toner cover.

Ensure that the toner cartridge is properly set in the machine.
Do not try to forcefully close the toner cover, as this may damage the machine.

14. Lower the scanning platform.

CHECK

Checking the packing materials
Ensure that the following packing materials are completely removed