Feeding documents with the Bypass Mode on the DR-6030C.
Article ID: ART108743
|
Date published: 05/11/2015
|
Date last updated: 08/16/2015
Description
Feeding documents one sheet at a time by hand is called the bypass mode.
Solution
Move the feed selection lever on the lower left side of the front of the scanner down.
Lowering the feed selection lever causes the document stoppers to go down.
The ISIS/TWAIN driver settings change to the manual feed mode automatically when the feed selection selection lever is lowered.
Place the document into the document feed tray one sheet at a time and adjust the position of the document guides.
When scanning small or short documents, adjust the document guides to the edges of the documents.
Start scanning from the application.
One sheet of the document is pushed against the document feed slot. The document is fed.
When scanning documents that are fastened together, such as invoices, set the edge of that is fastened together as the leading edge.
Note that when scanning with nonseparated feed, if you place several documents that are not fastened together on the feed tray at one time, they will be fed together.
In particular, very thin or curled documents will not be fed very well. In this case, lightly press on the leading edge of the documents as you feed them. When doing this, take care that your fingers do not go under the pickup roller.
After you finish scanning, close the document feed tray and the document eject tray extension to prevent damage to the scanner while it is not being used.
.
