Manually setting the IP address using IPv4

If the IP address is not assigned automatically, or you want to specify the IP address manually, follow the procedure below to specify the IP address.

note:

- It is recommended that the network administrator perform the following procedures.

- Before performing the following procedure, make sure that the machine is turned on and connected to a network.

- This machine is set by default to automatically draw an IP address using DHCP. If your network server or router is configured to provide a DHCP address, all you need to do is connect a network cable and turn on the machine. The machine will draw an IP address automatically.

- This machine also supports automatic IP addresses using BOOTP and RARP protocols. If you use these protocols, select [DHCP] at step 7 of the following procedures.

- This machine supports IPv6.

1. Press (Additional Functions).

Press (Additional Functions).

2. Press [System Settings].

3. Press [Network Settings].

4. Press [TCP/IP Settings].

5. Press [IPv4 Settings].

6. Press [IP Address Settings].

7. Press [IP Address], then enter the IP address using (Numeric Keys).

If you specify an IP address using DHCP, BOOTP, or RARP, press [DHCP], [BOOTP], or [RARP]. One of the DHCP, BOOTP, or RARP settings can be selected at any one time.

8. Press [Subnet Mask] and [Gateway Address] and specify the settings in the same way.

9. Press [OK].

10. Press the main power switch on the right side of the machine, wait at least 10 seconds, and then press the main power switch to ?I? side.