|
When canceling printing, press the <Stop/Reset> button.
To continue printing, press the <OK> button.
After printing is completed, replace the ink tank with a new one as soon as possible.
The machine may get damaged if the ink tank is not replaced and printing is continued.
|
The following ink tank cannot be
recognized.
|
|
More than one ink tank of the
following color is installed
|
|
The remaining level of the following
ink cannot be correctly detected.
|
An ink tank that was once used or was refilled may be installed.
Replace the ink tank.
Although it is possible to continue printing by pressing the <Stop/Reset> button for more than five seconds, this operation will disable ink detection and the printer will not be able to detect the remaining ink level.
Please note that problems caused by ink refill are not covered under the warranty.
Replace the ink tank.
|
Some ink tanks are not installed in
place.
|
|
This paper is not compatible with duplex printing.
|
The following papers are compatible with duplex printing: A4 / Letter / A5 / B5 / 5" x 7".
Press the <OK> button to eject the printed paper and resume printing from the front side of the next sheet.
Please note that the data which is supposed to be printed on the back side of the paper will not be printed if this error occurs.
|
Auto head align has failed.
|
Automatic print head alignment failed.
Press the <OK> button to clear the error.
Check the following list and repeat the automatic print head alignment procedure.
- Check if letter or A4-sized paper is loaded in the auto sheet feeder.
- Check if the paper output slot is not exposed to a strong light source.
- Print a nozzle check pattern to check the status of the print head.
If the problem continues, perform manual print head alignment.
|
Incompatible device detected.
|
Communication with the connected camera is not possible.
Disconnect the cable from the camera and check the following items and try printing again.
1) Check if the camera is compatible with PictBridge or Canon Bubble Jet Direct.
If the camera is not PictBridge or Canon Bubble Jet Direct compatible, Camera Direct Printing is not possible.
2) Depending on the model or brand of your camera, you may have to select a print mode compliant with PictBridge before connecting the camera.
Perform necessary operations according to the instruction manual supplied with your camera.
3) A specified period of time may have elapsed without receiving a response from the digital camera.
Disconnect and reconnect the cable from the camera to refresh hardware detection.
|
The waste ink absorber is almost full.
|
Press the <OK> button to clear the error.
You can continue printing; however, when the waste ink absorber becomes full, you will no loger be able to print
Waste ink absorber is a part inside the printer, which absorbs ink used in the cleaning operations, etc.
|
Print head is not installed./The type of print head is incorrect.
|
|
The card is currently write-enabled.
|
|
There are no photos in memory card.
|
|
|
|
|
Clear the jam.
Paper is likely to jam in the following instances.
1. Confirm there is no foreign material in the paper feed areas.
2. Verify recommended paper is loaded.
3. Verify paper is loaded properly and in the correct paper source.
4. Check if recommended paper is used and the number of sheets does not exceed the paper loading limits.
If the error is not resolved, a printer service error may have occurred. For support and service options, sign into (or create) your Canon Account from the link below.
My Canon Account
|
|
Close the inner cover and press the <OK> button.
If the inner cover is opened during printing, the printer may get damaged.
|
****
Error code
(where **** = an alpha-numeric digit)
|
1. Turn off the machine.
2. Unplug the power cord from the power source.
3. Wait about ten minutes, plug the power cord back in and power on the machine.
If the error is not resolved, a printer service error may have occurred. For support and service options, sign into (or create) your Canon Account from the link below.
My Canon Account
|