Perform Direct Printing from a Canon digital camera.
Note: The remaining ink warning can not be displayed through the camera.
- To display the images to print, set the digital camera to replay mode.
Note: If the replay mode does not start, switch to the replay mode following the directions in the manual packaged with the digital camera.
- Press the digital camera's <Set> button to display the Print menu.
- Select 'Style' and specify the paper size, borderless or bordered printing, and the date printing on or off setting.
- After specifying the style, select 'Print' and then press the <Set> button to start printing.
Note: When performing Direct Printing from a digital camera or digital video camera, error messages may be displayed on the device. The displayed error messages and the procedure to correct are as follows:
Camera Error Message
|
Possible Cause
|
Possible Solution
|
Printer in use
|
Images are being printed from the computer.
|
Wait until printing ends.
|
Printer warming up
|
The printer is warming up.
|
Wait until warm-up ends.
|
No Paper
|
No paper is loaded.
|
Load the paper in the printer and press the Resume/Cancel button on the printer.
|
Paper Jam
|
A paper jam has occurred in the printer.
|
Remove the jammed paper, load new paper, and press the <Resume/Cancel> button.
|
Printer cover open
|
The print head cover is open.
|
Close the print head cover.
|
No print head
|
No print head is installed. (The Power lamp on the printer flashes six times)
|
Install the print head according to the Easy Setup Instructions.
|
No print head
|
The print head is defective. (The Power lamp on the printer flashes six times)
|
The print head may have problems. Contact the Customer Care center.
|
Waste tank full
|
The waste ink absorber (the waste ink tank) is nearly full. *
|
Press the Resume/Cancel button on the printer to recover from the error. Printing is possible for a while. Contact the Customer Care Center as soon as possible.
|
No Ink
|
An ink tank is not installed.
|
Install an ink tank. Be sure to press on the <Push> mark of the ink tank to ensure it is firmly seated. |
A printer problem has occurred |
The remaining battery power is insufficient (The printer's power lamp blinks 10 times) |
- Turn the printer off.
- Connect the packaged Universal AC Adapter, or install a fully-charged battery.
- Turn the printer on.
|
A printer problem has occurred |
An error requiring service has occurred. (The printer's power lamp in orange and green blinks alternately.)
|
- Turn the printer off
- Remove and re-connect the power plug
- Turn the printer on again.
If the problem persists, contact the Canon Customer Care center.
|
* The waste ink absorber (the waste ink tank) is a part in the printer that absorbs ink used in operations such as print head cleaning. If this error has occurred, service of the printer may be required.