You can use the transmitter button to select either single or continuous exposure mode
- When the receiver is set to 1SR, select the film wind mode that matches the single exposure / continuous exposure setting on the transmitter.
Single Exposure
Set the control mode selector on the transmitter to (single exposure)
Point the signal emitter at the receptor and press the transmitter button halfway to activate the light metering
Check that the Ready Lamp on the transmitter is lit and then press the button all the way down
|
Continuous Exposure
Set the control mode selector on the transmitter to (continuous exposure)
Point the signal emitter at the receptor and press the transmitter button halfway to activate the light metering
Check that the Ready Lamp on the transmitter is lit and then press the button all the way down
- The film advances continuously as long as the signal transmitter is pointed at the receptor and the transmitter button is held pressed
To stop the continuous exposure, remove your finger from the transmitter button while pointing the transmitter at the receiver.
|