|
|
An ink cartridge is empty.
To cancel printing, press the Stop/Reset button.
To continue printing, press the OK button.
After the printing finishes, replace the empty ink cartridge.
Printing with an empty ink cartridge may cause machine malfunction.
|
|
The ink cartridge may not be set properly, or an ink cartridge not for the machine may be installed.
Install the proper ink cartridge for the machine.
Make sure to install the ink cartridges even when you set the machine to use only one ink cartridge in printing.
If one of the ink cartridges is missing, this error is indicated.
|
|
The ink cartridges are not installed in the proper position.
Install each ink cartridge in the proper position.
|
|
An ink cartridge not for the machine may be installed.
Install the proper ink cartridge for the machine.
|
|
A used ink cartridge may be installed, or the ink cartridge is empty.
Replace the ink cartridge.
By pressing the OK button, printing can be done without replacing the ink cartridge. However, the remaining ink amount cannot be detected properly, so the function to detect the remaining ink amount does not operate.
|
|
Since the memory card is currently write-enabled, printing is not possible.
Set to read-only mode.
|
|
Some images in the memory card may not be in a supported format. Images listed below cannot be printed directly from a memory card. Print them from a computer.
- Images edited on the computer
- Images in a format other than JPEG or TIFF
- Images with double-byte characters used in the file name
- Images saved in a folder nested 5 or more layers deep
|
|
The machine cannot communicate with the connected camera.
Disconnect the cable between the machine and the camera to clear the error.
Confirm the following, then print again.
1. Confirm that the camera you are using supports PictBridge or Canon Bubble Jet Direct.
If the camera does not support either one, the machine cannot print directly from the camera.
2. Set the camera in PictBridge print mode before it is connected to the machine. This is required before printing for some cameras that support PictBridge.
Please refer to the camera instructions for more information about procedures required before and after connection to the machine.
3. There may have been no response from the camera for the prescribed time.
Re-connect the cable between the camera and the machine.
|
|
The waste ink absorber is getting full.
Press the OK button to clear the error.
Printing can be done until the waste ink absorber becomes full.
The waste ink absorber is a part inside the machine, which absorbs ink used in the cleaning operations, etc.
|
|
Turn the machine off, and remove the power plug from the outlet.
About ten minutes later, plug it in again, and turn the machine on.
|
|
The machine has failed in scanning the head alignment sheet.<BR>Confirm that all the boxes in the head alignment sheet are filled in; place the sheet in the correct position and orientation; then, do the print head alignment again.
If the machine is connected to the computer via the cable, and the MP driver is installed, try the print head alignment from the MP driver.
|
|
If paper is not set, set paper and press the OK button. When paper is set, check each item and do printing again.
1. Confirm that unusable paper is not set.
2. Confirm that the paper is set properly.
3. Confirm that recommended paper is used, and the number of sheets set in the auto sheet feeder is within the limit.
4. Cleaning the paper feed roller may resolve the error.
|
|
Remove the jammed paper.
If paper jam frequently occurs, check the following:
1. Confirm that no foreign material is inside the machine.
2. Confirm that unusable paper is not set.
3. Confirm that the paper is set properly.
4. Confirm that recommended paper is used, and the number of sheets set in the auto sheet feeder is within the limit.
|