You can set a different output for each receiver unit (A, B and C) as follows.
|
1. On the sender unit, press the <MODE> button and select M
2. Press the <SEL/SET> button and select <RATIO)
- Pressing the <SEL/SET> button changes the selection in the following loop:
3. Press the <-> button to select RATIO ON A:B or A:B:C
- RATIO ON A:B or A:B:C will blink
4. Press the <SEL/SET> button
- A and the flash output display will blink
5. Press the <+> or <-> button to set the flash output for A
6. Press the <SET/SEL> button
- B and the flash output display will blink
7. Press the <+> or <-> button to set the flash output for B
8. Press the <SEL/SET> button
- C and the flash output display will blink
9. Press the <+> or <-> button to set the flash output for C
10. Press the <SEL/SET> button to register the settings
|
- If there are only two receiver units (A and B), steps 9 and 10 may be omitted
- After you complete the settings, you can check the respective flash output for receiver units A, B and C pre pressing the <+> or <-> button
- Press the sender unit's lamp to test fire the receiver units