| Search Results |
 |
EOS 3 : How to unload a roll of film.
|
After the films last frame is exposed, the camera rewinds the film automatically
|
|
|
EOS 3 : How to set and use Multi-Spot Metering
|
The exposure setting obtained with multi-spot meter readings are canceled in the following cases: After taking the last spot meter reading, 16 seconds elapsed You press the
|
|
|
PB-E2 Power Drive Booster : How to attach the unit to the camera
|
How to attach the unit to the camera
|
|
|
EOS 3 : How to set exposure compensation
|
Exposure compensation is used to alter the camera's standard exposure setting. While looking through the viewfinder, you can use either the
|
|
|
EOS 3 : How to change the focusing screens
|
You can interchange the camera's focusing screen to suit the picture-taking application. You must also set C.Fn-0 so that the criteria for the correct exposure suits the focusing screen
|
|
|
EOS 3 : How to set flash exposure compensation
|
With the camera , you can set the EOS-dedicated Speedlite's flash exposure compensation amount up to +/-3 stops in 1/3-stop increments While pressing the button, turn the
|
|
|
PB-E2 Power Drive Booster : Checking the battery level status
|
Check battery level with the camera . For details, refer to the camera's instruction booklet
|
|
|
EOS 3 : How Shutter Priority (Tv) mode works.
|
In this mode you set the desired shutter speed and the camera set the aperture automatically to suit the subject brightness A faster shutter speed can freeze motion and a slow shutter speed can achieve a blurred effect While pressing the <MODE> button, turn the
|
|
|
EOS 3: How Aperture Priority (Av) mode works.
|
In this mode, you set the desired aperture and the camera sets the shutter speed automatically to suit the subject brightness
|
|
|
EOS 3 : How to calibrate the Eye-Control Focus Point Selection system
|
You calibrate the camera by looking at a blinking focusing point in the viewfinder and then pressing the shutter button. Your do this for four focusing point while holding the camera horizontally and again while hold the camera vertically. Therefore you have to follow the calibration procedure eight times There are three calibration channels (CAL 1, 2, 3) which can store different calibration data.
|
|
