Search Results |
|
Settings and Activity Reports- FAX-JX210P
Note: TX REPORT PRINT ERROR ONLY: OUTPUT YES:
|
|
|
Different ways to send a fax (JX210P)
If all redialing attempts are unsuccessful, the fax will cancel the transmission. You can set the fax to print the ERROR TX REPORT to remind you that the transmission was not completed .
|
|
|
Printing a report on the FAX-JX210P
TX REPORT (Transmission Report) Normally the fax does not print an activity report for transmitting, but you can set the fax to print an activity report every time you send a document. You can set the fax to print an activity report only when an error occurs during transmitting. RX REPORT (Reception Report) Normally the fax does not print an activity report for receiving, but you can set the fax to print an activity report every time you receive a document.
|
|
|
Set RX (Receive) Start Speed to a slower setting (FAX-JX210P)
If phone line conditions are less than perfect, transmission (send) and reception (receive) problems can occur. Decrease the reception (RX or receive) speed if frequent fax transaction error messages appear on the LCD.
|
|
|
Sending a fax on the FAX-JX210P
Sending Documents If an error occurs during sending, the fax beeps intermittently for a few seconds and an error message appears on the LCD. If this happens, correct the problem and then press <Stop>, then try sending the document again.
|
|
|
Initial Hardware Setup - FAX-JX210P
important: If the Holder moves to the right side, close and reopen the Cover to return the Holder to the left. reference: If an error message is displayed on the LCD, refer to .
|
|
|
Changing the volume settings FAX-JX200 / JX210P
Volume Control ALARM VOLUME Set the volume of the error alarm sound. 0 (off)/1/2/3
|
|
|
Setting ECM TX to ON / OFF (FAX-JX210P)
Enable / disable ECM (Error Correction Mode) when sending a fax. * Select [ON] to send faxes with error correction. If telephone line conditions are poor, the time to send a fax will take longer.
|
|