Search Results |
|
Cannot Send a Fax
Has the Power Switch Been Just Turned ON? ... Has an error occurred during a transmission? ... Check the display for an error message . Print the Communication Management Report to check for errors . ... Is <Busy/No Signal> shown in the error transmission report?
|
|
|
User Support Tool
Do not turn OFF the power of the machine until the restart is complete. ... If any of the error messages shown below are displayed, follow the remedy procedure to resolve the problem.
|
|
|
Setting Send Result Reports to Print Automatically
Transmission failed. If an error code is displayed, see the "e-Manual" (HTML manual) in the CD-ROM supplied with the machine. 1. Press [
|
|
|
Setting the Paper Size and Type
An error message appears or the machine may not perform as expected.
|
|
|
If You Cannot Receive a Fax
Check the display for an error message . Print an Activity Report and check for an error.
|
|
|
imageCLASS/ Faxphone Firmware Update Instructions
PDF instructions for updating firmware
|
|
|
Cleaning the Machine
Clean the exterior of the machine and ventilation slots. 1. Turn OFF the power switch, and then disconnect the power cord. 2. Clean the exterior of the machine with a soft, well wrung out cloth dampened with water or a mild detergent that has been diluted with water.
|
|
|
Cleaning of imageCLASS Products
Make sure the device is powered down and unplugged before cleaning. Wait until surfaces are dry before plugging in and powering the device back on.
|
|
|
Installing the FAX L Drivers
Connect the USB cable after software installation is complete. Make sure that the machine is powered ON before connecting the USB cable.
|
|
|
Adjusting the Volume
] to highlight <On> (sound enabled) or <Off> (sound disabled), and then press [ OK ]. If <Only When Error Occurs> is selected, the machine makes a sound only if an error occurs. Proceed to step 5.
|
|