| Search Results |
 |
Normal Copying-PC 400 Series
|
Normal Copying If the copier has not been used for a long period of time, before operation move the platen by hand to the right, left and back to the center. Paper jams are most often caused by wrinkled or curled copy paper usage or by turning the power switch OFF while the copier is copying. Always turn on the power switch slowly.
|
|
|
If Paper Jams Occur Frequently (Cleaning the Static Charge Eliminator) (PC940/PC941)
|
When a paper jam occurs, first check to make sure the copy paper fits securely in the cassette tray and that the length guides of the cassette tray are adjusted correctly. If a paper jam occurs even though the cop paper is set securely in the cassette tray, follow the procedure below to clean the static charge eliminator.
|
|
|
Making Two-Sided Copies
|
Making Two-Sided Copies Place the first original on the platen glass, then proceed to copy. The side that you want to copy must face downward.
|
|
|
Cleaning the Copier-PC 400 Series
|
Cleaning the Copier To clean the underside of the platen glass, first remove the multi-stack tray from the main unit. To do so, hold the corners of the multi-stack tray with hands and lightly push inwards on the two corners to detach the tray.
|
|
|
Copying Thick Books or Large Originals
|
Copying Thick Books or Large Originals Place your original on the platen glass. Then, press the < Start > (
|
|
|
Enlarging/Reducing Using Preset Copy Ratios-PC 940
|
Enlarging/Reducing Using Preset Copy Ratios When you press the <Preset Copy Ratio> key, the preset copy ratios will appear in the following order: Press the < Start > ( ) key.
|
|
|
Making a Copy-PC 940
|
Close the platen glass cover gently to avoid catching your hand, as this may result in personal injury. Press the < Start > button.
|
|
|
Setting the Copy Quantity
|
Setting the Copy Quantity key. Press the < Start > ( ) key.
|
|
|
Replacing and Storing Cartridges-PC 100 Series
|
When your toner starts to run low, perform the following procedure to make sure all the toner is used. After performing this test, if the resulting copy does not improve in quality then replace the cartridge with a new one.
|
|
|
Replacing and Storing Cartridges-PC 400 Series
|
Test your cartridge before replacing it When your toner starts to run low, perform the following procedure to make sure all the toner is used. After performing this test, if the resulting copy does not improve in quality then replace the cartridge with a new one.
|
|
