| Search Results |
 |
Disable the MultiPASS Toolbar from launching on startup. - C755
|
Untitled Document MultiPASS Toolbar Two error messages MultiPASS C3500
|
|
|
Start / restart the MP Service - C755 / C555 / C530 / C560
|
Untitled Document MultiPASS Toolbar Two error messages MultiPASS C3500
|
|
|
ERROR: 0x80070725 - Incompatible version of the RPC stub - Setup will now terminate
|
The error 'Incompatible version of the RPC stub' is caused by an incompatible version of a DLL that was installed on the system, such as Oleaut32.dll, Olepro32.dll, Asycfilt.dll, Stdole 2 .tlb. For example, version 3.50 of Oleaut32.dll is installed and used only by Windows XP and so causes this error if it is installed on a machine running any other operating system.
|
|
|
Canon BJC_4300 File Creation (C3500, C5500, C530, C560, L6000)
|
Canon BJC_4300 File Creation (C3500, C5500, C530, C560, L6000) Error occurred during file creation." Solution: If the installation completed without an error and the file creation message only appears while printing or opening the printer's property, search for and delete BJSYS38.CFG (this file will be located in C:\WINDOWS\NTBJRSTR\. If the system hangs and the message appears while installing the driver, wait approximately 2 -3 minutes and then 'End Task' on the Setup
|
|
|
CSTART.DLL error
|
CSTART.DLL error into the CDROM drive. If you received two CDROM disks with your MultiPASS, insert the one that says Install Me First
|
|
|
Delete queued print jobs to resolve printing errors (Windows)
|
If a print job is corrupt and does not print clearly, does not print at all or is preventing other queued jobs from printing, delete the queued job. From the 'Document' menu, select 'Cancel'. Repeat steps two and three to cancel another print job. If the print job cannot be cancelled or will not stop printing, shut down the computer, disconnect the printer cable and then restart the computer.
|
|
|
The Message "A Printer Error Has Occurred" Appears When Trying to Print (Windows)
|
If this does not help, stop the Print Spooler by following steps 1 and 2 above. Then, instead of restarting the Print Spooler, click Stop
|
|
|
Error writing to LPT1 or Spool32 error (C2500)
|
Error writing to LPT1 or Spool32 error (C2500) When prompted, replace Disk 1 with Disk 2 and click 'OK'. Proceed through printer installation by inserting the appropriate disk until the printer setup is complete.
|
|
|
Enable the PHOTO INK PRINT setting - C755 / C555
|
RX (Reception) Settings Menu 2 ... Enables/disables memory reception of a document (e.g. when an error occurs).
|
|
|
Load paper properly - C3500 / C5500
|
Load paper in the multi-purpose tray as follows. If an error message appeared on the display, after correcting the problem, press <STOP> to clear the error and continue printing. 2 . Raise the paper rest until it stops (1), then move the paper guide to the left to match the size of your paper ( 2 ). ... Slide the paper guide snugly against the left edge of the stack ( 2 ). ... (75 g/m 2 ) plain paper.
|
|
