Canon Knowledge Base

Filters

Search Results

Here is a list of the Parts and controls - nomenclature for the SX-80 Remote Control

Use the remote control within an angle of 30° in any direction from directly in front of the infrared remote receiver. The remote control may be inoperative if there is an obstacle between the remote control and main unit or the infrared remote receiver on the main unit is exposed to direct sunlight or strong light of lighting equipment. When you use two projectors at the same time, you can change the channel settings to prevent the two remote controls from interfering with each other.

Setting Up the Projector

Lift the front side of the projector and push the adjusting foot lock button to extend the adjustable foot. 2 Raise the image to the desired height angle, then release the button to lock the foot in place.

How to Change the Setting Display Status in the SX-80 Projector Menu

This mode is available when you select [ANALOG PC-1], [ANALOG PC- 2 ], [DIGITAL PC], HDMI (720p, 576p, 480p)] or [COMPONENT (720p, 576p, 480p)] for input signal. It is not available for an image having a resolution higher than SXGA+ or visual software having a resolution of 1080i, 1080p, 1035i, 576i or 480i.

Here are the Maintenance and Cleaning and Lamp Replacement Procedures for the SX-80 Projector

1 Turn off the projector, disconnect the power plug from the AC outlet, and let the projector stand for at least 1 hour. 2 Remove the filter cover by pushing the position of the arrow. 3 Remove the air filter.