| Search Results |
 |
LCD Messages FAX-JX200
|
LCD Messages The fax will resume printing when it has cooled down. An error requiring servicing might have occurred. Turn OFF the machine, and unplug the power cord of the machine from the power supply.
|
|
 |
User Support Tool
|
� A critical error may occur if another computer or application communicates with the machine (for example, when printing is performed) while the firmware is being updated. In addition, do not turn OFF the machine or disconnect the interface cable (USB or LAN cable) while the firmware is being updated. If a critical error does occur (the machine is turned ON but does not start up, etc.), the machine will need to be repaired .
|
|
|
Remove foreign object from paper feed area (B95)
|
is displayed, follow this procedure to remove paper or obstructions from the machine. Remove any remaing paper from the ASF . ... After paper is removed from the ASF , open the document tray. ... Look in the ASF area for an obstruction (such as a paper clip, staple, tape, etc.) and then remove it.. ... If paper is not visible in the ASF , open the printer cover and remove it from there.
|
|
|
Load paper properly into the B45
|
Fan paper prior to inserting it into the Automatic Sheet Feeder ( ASF ). Remove any remaining paper from the ASF . ... If an error message appears on the display, press <STOP> to clear the error .
|
|
|
Different ways to send a fax (JX210P)
|
2. Use the numeric buttons to dial the number of the information service . 3. When the recorded message of the information service answers, press [Tone] ([ ... 4. Use the numeric buttons to enter the numbers requested by the information service . 5. When you have finished using the service , press [Hook] or hang up the Handset. ... A pause at the end of a number is fixed at 10 seconds. ... You can set the fax to print the ERROR TX REPORT to remind you that the transmission was not completed .
|
|
|
Fax Error Codes for L120
|
|
Fax Error Codes (L90)
|
|
Set RX (Receive) Start Speed to a slower setting (FAX-JX200)
|
If phone line conditions are less than perfect, transmission (send) and reception (receive) problems can occur. Decrease the reception (RX or receive) speed if frequent fax transaction error messages appear on the LCD.
|
|
|
Receiving faxes in memory when a problem occurs L170
|
Receiving faxes in memory when a problem occurs The machine will automatically receive incoming faxes into its memory if it encounters a problem that prevents it from printing normally. The LCD will display [RECEIVED IN MEMORY] and a message showing the problem. See below the error messages , their cause and the action you need to take to correct the problem.
|
|
|
Setting Send Result Reports to Print Automatically
|
Transmission failed. If an error code is displayed, see the "e-Manual" (HTML manual) in the CD-ROM supplied with the machine. 1. Press [
|
|
