| Search Results |
 |
Operating the Camera in Mobile Camera Viewer
|
(5) Control/Release button Enables or disables camera control privileges. (6) Disconnect button
|
|
|
[Access Control] IPv4 Host Access Restrictions
|
[Access Control] IPv4 Host Access Restrictions (1) [Apply Host Access Restrictions] - Set IPv4 host access restrictions to [ Disable ] or [Enable]. (2) [Default Policy] - If IPv4 host access restrictions are applied, select [Authorize Access] or [Prohibit Access] for the default policy.
|
|
|
Overview of Viewer
|
Users with camera control authority can use this viewer. You can set the applicable options to enable/ disable authentication, etc.
|
|
|
Restore Settings
|
You must not turn off the camera while it is performing the [Restore Settings] operation. Turning off the camera at this stage may result in disabling its ability to boot correctly.
|
|
|
Display Screen of Camera Angle Setting Tool
|
(10)[Zoom] button - The button to operate the zoom ratio. (11)[Control Assist Display] selection box - Select whether to [Enable] or [ Disable ] operation assist in the image display area. (12)[Control Button Display] selection box - Select whether to [Enable] or [Disable] the [Pan] button and [Tilt] button in the image display area.
|
|
|
[Date and Time] Setting Date and Time
|
If [Auto-Setting of NTP Server] is enabled, camera time is automatically synchronized with the time of the NTP server at the address obtained from the DHCP server. In order to enable this setting, you must change [Network] > [IPv4 Address Setting Method] to [Auto (DHCP)] To select a particular NTP server, disable [Auto- Setting of NTP Server], and then enter the IP address or host name of the NTP server in [NTP Server].
|
|
|
[SSL/TLS] Setting HTTP Communication Encryption - Certificate Management
|
However, if SSL communications are enabled, the certificate cannot be deleted. Set [SSL Communications] to [ Disable ] before deleting a certificate. The deletion will take effect after rebooting.
|
|
|
Preset Setting Tool - Specifying Detailed Settings
|
Changes to preset settings are not reflected in already connected viewers. You can disable presets in the viewer by clearing the [Show in viewers] checkbox under [Detailed settings]. Preset positions cannot be set in the digital zoom area.
|
|
|
Intelligent Function Setting Tool - Flow of Settings
|
To enable detection settings, select [Enable these detection settings]. Clear this checkbox to disable a setting. 3
|
|
|
[Camera] Setting Initial Camera Settings and External Device Name
|
Set the maximum slow shutter time to be used when in auto exposure mode when capturing video in a dark place. Select [ Disable ], [1/15], [1/8], [1/4] or [1/2]. As slower shutter speed generates residual images when capturing a moving subject, select an appropriate time according to the capture conditions
|
|
