Change Paper Size / Media Type

You can change the print settings such as the paper size and media type when in Copy mode.

1. Confirm that the printer is powered on. If the printer is not on, press the ON/OFF button.
   
   
   
   
   
2. Open the Paper Support, then pull out the Paper Support Extension.
   
   
   
   
3. Load paper in the Rear Tray, print side facing up with the short-side down.
   
   
   
   Note: Load the exact number of pages in the Rear Tray to make 10 to 19 copies.
   
   
4. Lift the document cover and place a document on the platen glass.
   
   Note:
   * Regardless of the document size, place it with the long-side toward you.
   * Place the document face down on the platen glass.
   * Align the document with the alignment mark (shown as the arrow) on the lower right corner of the platen glass.
   * The machine cannot scan the area within approximately 3 mm of the front and right edges of the platen glass.
   
   
   
   < 1 > Alignment Mark
   
   
5. Gently close the document cover.
   
   
6. Press the <Paper> button repeatedly until the preferred paper size and type is illuminated. The options are as follows:
   
   
   
   
7. Press the <+> button repeatedly to select the number of copies. (The maximum number of copies is 20.)
   
   1. When making 20 copies, press the <+> button repeatedly to select [F]. The letter F will display after number 9.
      
   2. When making 10 to 19 copies, press the <+> button repeatedly to select [F] and then load the exact number of pages in the Rear Tray.
      
      For example, to make 15 copies, load 15 blank pages in the Rear Tray.
      
      Note: The number of copies can be set from 1 to 9 and 20 (F is the selection). So, it is important to load the exact number of sheets in the Rear Tray when making 10 to 19 copies.
      
   3. After copies from 10 to 19 are completed, the below error will appear <E> and then <2>. This is a normal function for this printer when making this number of copies. Press the Stop/Reset button to clear the error.
      
      
      
      The above illustration is of a PIXMA MP160.
      
      
8. To start copying, press the <Color> or <Black> button.
   
   
   
   
9. To cancel copying, press the <Stop/Reset> button.