Copy Intensity
You can adjust the copy intensity manually or allow the printer to automatically adjust the copy intensity.
Manual Copy Intensity
- Confirm that the printer is powered on and press the <Open> button. (The paper output tray will open.)
- Load paper in the auto sheet feeder in the portrait orientation.
- Lift the document cover and set a document on the platen glass.
Note:
- Regardless of the document size, place it face down in landscape orientation on the platen glass.
- Align the document with the alignment mark (shown as the arrow) on the lower right corner of the platen glass.
- The machine cannot scan the area approximately 3 mm from the front and right edges of the platen glass.
< 1 > Alignment Mark
- Close the document cover gently.
- Confirm that the printer is in Copy mode. If the printer is not in Copy mode, press the <COPY> button to switch into Copy mode.
- Change the copy intensity by pressing the right or left arrow.
Note:
* Pressing the left cursor button decreases the intensity.
* Pressing the right cursor button increases the intensity.
The above illustration will vary by model.
- Press the <Color> button for color copying, or the <Black> button for black & white copying. (The machine starts copying.)
- To cancel copying, press the <Stop/Reset> button.
Automatic Copy Intensity
- Press the <Settings> button. The [Settings] screen is displayed.
- Use the right or left cursor button to select [Settings 2] tab <4>.
- Use the up or down cursor button to select [Auto Intensity] <5>.
- Use the right or left arrow to select Auto intensity ON or Auto intensity OFF.
Note: If you set Auto intensity ON, printing is possible with automatically adjusted intensity, according to the document set on the platen glass.
- To complete Auto Intensity setting, press the <Settings> button.