The function for counting the documents before scanning is described below.
Solution
The function for counting the documents before scanning is described below.
Count-Only Mode
Counts the number of loaded document sheets by simply feeding them through the scanner.
The Count-Only mode is executed by the Count Only key on the control panel, and can be used to count document sheets even when no computer is connected.
Place the documents into the tray.
Press the Count Only key on the control panel.
The Count Only key lights blue when the Count-Only mode is enabled.
Press the Start key to start scanning and count the loaded document sheets.
To reset the page counter, press the Count Clear key for approximately two seconds while the Count Only key is lit.
Verify Scan
The scanner compares the document page count obtained from the Count-Only mode (or entered manually) with the actual count of document pages scanned, and an error message is displayed if the two counts do not match.
Setting the Count.
The document page count can be specified by using the count obtained from the Count-Only mode or by pressing the and keys to enter a number.
Select Verify Count in the ISIS/TWAIN driver settings.
Press the Start key to start scanning. "Verifying...' is displayed.
If the specified count is exceeded while scanning, or if the scanned count does not reach the specified count when scanning is finished, an error is displayed.
The specified count is exceeded while scanning
Scanning finishes without reaching the specified count