| Error Code |
Error Message |
Solution |
| 152 |
There is not enough memory. Exit other applications to increase available memory. |
- The memory required to start IJ Scan Utilitycannot be obtained; exit other applications.
|
| 153 |
The image you attempted to scan is in a size that cannot be opened in the specified application. Change the settings so that the image size is reduced. |
- Reduce the resolution or output size and scan again.
|
| 157 |
Cannot communicate with scanner for these reasons:
- Scanner is turned off.
- (If using Wired LAN connection) It is disconnected from Wired LAN.
- (If using wireless LAN connection) Signal strength is poor due to obstructions.
- Network connection is prohibited by security software.
- Different scanner on the network is selected.
Check the above and try scanning again.
If you still cannot communicate, restart the computer. |
- With network connection, check the connection status and reconnect as needed. If the same error message still appears, restart the computer.
|
| 201 |
A required file is missing or corrupted, or settings are incorrect.
Try the installation again. |
- Reinstall the scanner driver (ICA (Image Capture Architecture) driver) from our website.
- Reinstall IJ Scan Utility from our website.
|
| 202 |
An internal error has occurred. Take the following measures.
- Check the scanner status.
- Restart the scanner.
- Restart the computer, then try again.
- Reinstall the scanner driver. |
|
| 230 |
A scanner driver supporting this software is not installed. Install it and try again. |
- Reinstall the scanner driver from our website.
|
| 231 |
Cannot complete the scan. The disk space is insufficient. |
- Delete unnecessary files on the hard disk and scan again.
|
| 232 |
Cannot save the file. The disk is write-protected.
Cancel the protection or use another disk. |
- Cancel the write protection on the disk.
|
| 234 |
This scan function is not supported by the selected model. Select a different scan function. |
- Select a different scan function.
|
| 242 |
Cannot write file. |
- Check the access permission on the folder in Folder to Save Temporary Files in theSettings (General Settings) dialog orSave in in the corresponding Settings dialog .
|
| 243 |
Cannot read file. |
- Check the access permission on the folder in Folder to Save Temporary Files in theSettings (General Settings) dialog orSave in in the corresponding Settings dialog .
|
| 244 |
You do not have the required privileges to access the specified folder. |
- Grant access permission to the specified folder.
|
| 245 |
Text could not be detected. Make sure that the following conditions do not apply.
- The Document Language setting does not match the document language.
- There is no text in the document.
- Text that is not supported for detection is scanned. |
- Make sure the Document Language in the Settings (General Settings) dialog matches the document language.
- Make sure there is text in the document.
|
| 248 |
Scanner is not selected.
Click [Scanner Selection] to select scanner. |
- In the network selection screen, specify thescanner you want to use. Refer to "Network Scan Settings" for the setting procedure.
|
