Paper becomes jammed because the rollers are dirty.
| Article ID: ART107752 |
| |
Date published: 05/11/2015 |
| |
Date last updated: 08/15/2015 |
Description
Clean the rollers. (SF-300 Series)
Solution
- Pull the lock lever toward you and then fully open the panel unit.
The opne/close movement of the panel unit is linked to the up/down movement of the document eject tray. Do not press on the document eject tray when you open the panel unit.
- Open the Retard roller cover.
Do not use excessive force when removing or attaching the retard roller. Doing so may cause the roller to become deformed, resulting in feed errors.
- Lift up the roller lock lever
, and slide it in the direction of the arrow 
.
- Move the retard roller in the direction of the arrow , and then remove it from the shaft .
- Remove any dirt from the roller using a cloth that has been soaked in water and thoroughly wrung out.
- Replace the roller in the roller compartment inside the roller cover, and then align the notch in the roller with the shaft of the scanner.
- Slide the roller lock lever in the direction of the arrow, and then insert it into the hole of the retard roller.
- Lower the lever to lock the shaft of the retard roller into position.
- Close the roller cover. Make sure that you hear a click, which indicates the cover has returned to its original position.
- Open the Feed roller cover.
Do not use excessive force when removing or attaching the feed roller. Doing so may cause the roller to become deformed, resulting in feed errors.
- Lift up the roller lock lever , and slide it in the direction of the arrow .
- Move the feed roller in the direction of the arrow , and then remove it from the shaft .
- Remove any direct from the roller using a cloth that has been soaked in water and thoroughly wrung out.
- Align the notch in the shaft of the roller with the shaft of the scanner, and place the feed roller into position.
- Move the roller lock lever in the direction of the arrow, and then insert it into the hole in the feed roller.
- Lower the roller lock lever to lock the feed roller into position.
- Close the roller cover. Make sure that you hear a click, which indicates the cover has been returned to its original position.
- Gently close the panel unit. Press on sides of the unit until you hear a click, which indicates the unit is locked.
