Preparing for Time Syncing
When using a single receiver camera, connect a LAN cable to the Ethernet terminal of the sender and receiver cameras.
When using multiple receiver cameras, connect a LAN cable from the Ethernet terminal of the sender and receiver cameras to a hub. Up to 10 receiver cameras can be connected.
Use a highly shielded Category 5e or higher STP (Shielded Twisted Pair) Gigabit Ethernet cable.
Syncing the Time
Preparing the sender camera
First, set up the camera to use as a sender.
-
On the camera, press the button.
-
Select [: Network settings].
-
Select [Enable].
-
Select [Sync time between cameras].
- If the camera is already connected to another device, [Set [Connection settings] to [Disconnect]] is displayed. Select [OK] to end the connection.
-
Select [OK].
-
Select [OK].
-
Select [Sender].
- Select [OK] to go to the next screen.
- After the screen is displayed, the camera is ready.
Preparing receiver cameras
Set up cameras to use as receivers.
-
Follow steps 1–6 in Preparing the Sender Camera.
-
Select [Receiver].
- Select [OK] to go to the next screen.
-
Select [OK].
Syncing time between sender and receiver cameras
Sync the time on the sender and receiver cameras as follows.
-
Follow steps 1–6 in Preparing the sender camera and steps 1–3 in Preparing receiver cameras.
-
On the sender camera, select [OK].
- Check the number of receiver cameras, then select [OK].
- After the time is synchronized, the next screen is displayed.
-
Select [OK] on all of the cameras.