Using the Copy Function Directly From The Printer

Instructions how to make copies without using the computer.

1. Confirm that the printer is powered on and press the <Open> button. (The paper output tray will open.)
   
   
   
   
2. Load paper in the auto sheet feeder or the cassette in the portrait orientation.
   
   
   The above illustration shows a PIXMA MP950
   
   
3. Load a document on the platen glass or in the ADF (Automatic Document Feeder).
   
   Note:
   - Do not load thick paper such as a photograph in the ADF as it will cause a paper jam.
   - If you copy legal-size documents, make sure to load them in the ADF.
   
   
   Platen Glass:
   
   Note:
   Regardless of the document size, set it in the landscape orientation.
   
   a. Place the copying face down on the platen glass.
   
   b. Align the document with the alignment mark (shown as the arrow) on the lower right corner of the platen glass.
   
   Note: The machine cannot scan the area approximately 2 mm from the back edge of the platen glass and 2 mm from the left edge.
   
   
   
   < 1 > Alignment Mark
   
   c. Close the document cover gently.
   
   
   ADF:
   
   Note:
   - Set a document on the platen glass if you want to scan it at optimum quality.
   - When a document is set in the ADF, 2 mm from the leading edge of the document (the part that is first scanned) will not be scanned.
   
   a. Remove any documents from the platen glass.
   
   b. Open the document tray.
   
   
   
   
   c. Load the document in the ADF with the side you want to copy face up. If it is loaded correctly, you will hear a beeping sound.
   
   Note: When the Alarm volume in the Volume control is off, it does not sound.
   
   d. Align the document guides to sides of the document.
   
   
   
   
4. Confirm that the printer is in Copy mode. If the printer is not in Copy mode, press the <COPY> button to switch into Copy mode.
   
   
5. Check the copy settings, following the procedures below carefully.
   
   
   
   < 1 > Check the paper size and media type.
   
   < 2 > Use the up / down cursor button to specify the number of copies.
   
   < 3 > Use the right / left cursor button to adjust the intensity.
   
   Note: Pressing the right cursor button increases the intensity. Pressing the left cursor button decreases the intensity.
   
   
6. Press the <Color> button for color copying, or the <Black> button for black & white copying. (The printer starts copying.)
   
   Note: To cancel copying, press the <Stop/Reset> button.