The edges of the paper are dirty (iPF830/iPF840/iPF850)
Article ID: ART162645 |
| |
Date published: 10/01/2015 |
| |
Date last updated: 12/02/2015 |
Description
The edges of the paper are dirty (iPF830/iPF840/iPF850)
Solution
Solution |
Cause | Corrective Action |
The Platen has become dirty after borderless printing or printing on small paper. | Open the Top Cover and clean the Platen. |
The type of paper as specified on the printer does not match the type specified in the printer driver. | Make sure the same type of paper is specified on the printer as in the printer driver. |
Make sure the same paper type is specified in the printer driver as on the printer.
1. Press the [Stop] button and stop printing.
2. Change the type of paper in the printer driver and try printing again. |
The paper is wrinkled or warped. | Straighten out the wrinkles or curls and reload the paper. Do not use paper that has been printed on previously. |
A cut line is printed because [CutDustReduct.] is [On] in the Control Panel menu to reduce cutting dust. | If this function is not needed, set [CutDustReduct.] to [Off] in the Control Panel menu. |
The Printhead is set too low in the Control Panel menu. | In the Control Panel menu, set [Head Height] to [Automatic].
(See "
Adjusting the Head Height (iPF830/iPF840/iPF850)
") |
You are printing on heavyweight paper or paper that curls or wrinkles easily after absorbing ink. | For paper-based media such as Heavyweight Coated Paper, set the [VacuumStrngth] to [Strong] or [Strongest] in the Control Panel menu. If the paper still rubs against the printhead, set the [Head Height] in the Control Panel menu to a higher value than the current setting.
(See "
Adjusting the Vacuum Strength (iPF830/iPF840/iPF850)
")
(See "
Adjusting the Head Height (iPF830/iPF840/iPF850)
") |
For film-based media such as Tracing Paper, set the [VacuumStrngth] to [Standard], [Strong] or [Strongest] in the Control Panel menu. If the paper still rubs against the printhead, set the [Head Height] in the Control Panel menu to a higher value than the current setting.
(See "
Adjusting the Vacuum Strength (iPF830/iPF840/iPF850)
")
(See "
Adjusting the Head Height (iPF830/iPF840/iPF850)
") |
The Ejection Guide is soiled. | Clean the Ejection Guide. |
|
ID: 8202689800_EN_1
|