Caution
-
When replacing the lamp, turn off the projector, wait until the cooling fan stops, remove the power plug from the AC outlet, and let the projector stand for at least 1 hour. Otherwise, you may get burned because the main unit is very hot immediately after the projector is turned off.
-
Do not touch the inner glass surface when you replace the lamp. Otherwise, the projector's performance may degrade.
-
Make sure to handle the lamp carefully and correctly since it may explode if it is scratched or shocked.
- Do not remove screws unless specified.
Replacing Lamp
This projector uses the following lamp.
Lamp type No. SX6/X600: RS-LP02
SX60: RS-LP03
Replacing the Lamp
1 Turn off the projector, disconnect the power plug from the AC outlet, and then let the projector stand for at least 1 hour.
2 Loosen a screw with a flathead screwdriver and remove the lamp cover
|
|
3 Loosen two screws, pull up the handle, and then remove the lamp.
4 Fully insert a new lamp and secure it with two screws.
* After the installation, be sure to push down the handle.
|
|
5 Replace the lamp cover and tighten the screw.
6 Turn on the projector.
7 Bring up the menu and select [System settings] -> [Other settings] -> [Lamp counter].
8 Select [Reset] -> [OK] to reset the lamp counter
|
|