For the wireless setup for the Android terminal, follow the instructions below. NOTE: The procedures below are the ones for GALAXY S SC-02 B (Android 2.2). Step 1.
For details on wireless flash photography and operating the sender unit, see the sender unit's instruction manual. The procedure below applies to a sender unit attached to the camera and receiver unit( s ) controlled by wireless .
To prevent your sender unit from firing another photographer's receiver units, four channels are provided to differentiate your receiver units from unrelated ones. The sender unit and receiver unit( s ) in the same wireless flash system must be set to the same channel No.
Sample Wireless Flash System You can easily set up an E-TTL autoflash system with the 550EX, ST-E2 or MR-14EX as the sender unit and the 420EX as the receiver unit. Just set the 420 EX's wireless selector to <receiver> and position the receiver unit( s ) as desired within the wireless transmission range
Flash exposure compensation and other setting set with the sender unit will also be automatically set in the receiver units. Thus, you need not operate the receiver unit( s ). Wireless flash with the following setting can be done in the same way as with normal flash shooting
Make sure the sender unit's pilot lamp is lit and the receiver units are ready Press the pilot lamp to test the wireless transmission Focus the subject and take the picture.
With the optional Remote Controller RC-5 (optional), you can shoot remotely from up to about 5 meters/16.4 ft. in front of the camera. Point the signal transmitter toward the camera' s remote control sensor and press the signal button.