Search Results |
|
Optional accessories for the EOS C500 Mark II
Optional Accessories Use of genuine Canon accessories is recommended. The message [ Battery communication error ] is displayed if you use a non-genuine Canon battery pack, and user response is required* Note that Canon shall not be liable for any damages resulting from accidents, such as malfunction or fire, that occur due to use of non-genuine Canon battery packs.
|
|
|
Recovering clips on the EOS C500 Mark II
Some actions, such as suddently turning off the camera or removing the card while data is being recorded, can cause data errors in the resorded clip. In MEDIA mode, you may be able to recover clips with corrupted data using the following procedure.
|
|
|
Inserting and removing a CFexpress card on the EOS C500 Mark II
Inserting a CFexpress Card 2 Insert the card straight, with the label facing the back of the camera (the side with the battery compartment) all the way into one of the CFexpress card slots.
|
|
|
Inserting and removing an SD card on the EOS C500 Mark II
Inserting and Removing an SD Card 3 Insert the card straight, with the label facing the back of the camera (the side with the battery compartment) all the way into the SD card slot until it clicks.
|
|
|
Adjusting the Black Balance on the EOS C500 Mark II
Adjusting the Black Balance If the sensor is not completely shielded from light, [ Error ] will appear on the screen. Repeat the procedure from the beginning.
|
|
|
Relay recording and double slot recording with the EOS C500 Mark II
Double Slot Recording If a card becomes full during double slot recording, recording on both cards will stop. On the other hand, if an error occurs with one of the cards, recording will continue on the other card.
|
|
|
Names of Parts (EOS C500 Mark II)
Camera x4) Battery compartment MON. terminal
|
|
|
Recording audio on the EOS C500 Mark II
Audio Settings and Recorded Audio Channels Audio Setup] > [CH2 Input] setting. 4 When the EU-V2 with a V-mount battery is attached to the camera, the option to use the INPUT terminals on the camera appears as [INPUT Terminals (Camera)] instead of [INPUT Terminals].
|
|