| Search Results |
 |
What batteries can I use with my camera?
|
The message [ Battery communication error .] is displayed if you use a non-genuine Canon battery pack, and user response is required.
|
|
|
Batteries may need to be recharged or replaced.
|
Batteries may need to be recharged or replaced if an error persists after battery recharge, or the unit may require a service evaluation. If the battery is currently in the device, and it is not working properly, remove the batteries and wait for 30 seconds and re-insert the batteries. In doing so, if your camera has a back-up or date and time battery, remove this battery as well.
|
|
 |
E
|
In the unlikely event that an error occurs during the firmware update, please remove the battery and stop the update procedure. Check the remaining battery level and the firmware on the card, and if there are no problems, start over the procedure from the beginning.
|
|
|
Explanation of "Exx" error codes on early PowerShot cameras.
|
I am getting an Exx error message, what can I do? Occasionally, the error detected may be an isolated or intermittent instance. To check this, remove the battery for about 20 minutes, then reinsert the battery to see if the error code will reset. Also, since some error codes refer to the ability to read the information on the CF card, you may try a different CF card or reformat the CF card.
|
|
|
List of error messages that can appear on the LCD monitor of the PowerShot E1.
|
Erase the images to open space for new images, or insert an empty memory card. Change the battery pack. Battery charge is insufficient to operate the camera.
|
|
|
What to do if your receive a Lens Error Message
|
This error may occur if the lens is held while it is moving, or when the camera is used in dusty or sandy locations. Remove the main battery and replace it with a fully charge one and turn the camera back on. If that does not correct the error, or if the error is frequently displayed, it may indicate camera damage.
|
|
|
List of error messages on the LCD of the PowerShot SX10 IS.
|
Please note that formatting will erase all the existing images and other data. Change the batteries . Battery charge is insufficient to operate the camera.
|
|
|
Error messages that appear on the LCD monitor (PowerShot ELPH 180 / IXUS 175)
|
Either erase unneeded images or insert a memory card with enough free space. Charge the battery Battery charge is insufficient to operate the camera. Replace it at once with a charged one or recharge the battery.
|
|
|
What are the error messages that appear on the LCD monitor? (PowerShot ELPH 135, 140IS, and 150IS)
|
memory card with enough free space. Charge the battery Battery charge is insufficient to operate the camera. Replace it at once with a charged one or recharge the battery.
|
|
|
What are the error messages that appear on the LCD monitor? (PowerShot S120)
|
Insufficient space on card There is not enough free space on the memory card to shoot or edit images. Either erase unneeded images or insert a memory card with enough free space Touch AF unavailable Touch AF is not available in the current shooting mode Touch AF canceled The subject selected for Touch AF can no longer be detected Charge the battery Battery charge is insufficient to operate the camera. Replace it at once with a charged one or recharge the battery.
|
|
