Ask a Question
FiltersClear
CMS-CATEGORY_REF
CANON (8)
Content Source
Articles (8)
Products
Fax-Jx210p (8)
 
 
Search Results
CMS-XML Set RX (Receive) Start Speed to a slower setting (FAX-JX210P)
If phone line conditions are less than perfect, transmission (send) and reception (receive) problems can occur. Decrease the reception (RX or receive) speed if frequent fax transaction error messages appear on the LCD.
CMS-XML Sending a fax on the FAX-JX210P
Sending Documents If an error occurs during sending, the fax beeps intermittently for a few seconds and an error message appears on the LCD. If this happens, correct the problem and then press <Stop>, then try sending the document again.
CMS-XML Different ways to send a fax (JX210P)
If an error occurs during sending, the fax beeps intermittently for a few seconds and an error message appears on the LCD. If this happens, correct the problem and then press [Stop/Reset], then try sending the document again.
CMS-XML Initial Hardware Setup - FAX-JX210P
important: If the Holder moves to the right side, close and reopen the Cover to return the Holder to the left. reference: If an error message is displayed on the LCD, refer to .
CMS-XML Changing the volume settings FAX-JX200 / JX210P
Volume Control ALARM VOLUME Set the volume of the error alarm sound. 0 (off)/1/2/3
CMS-XML Setting ECM TX to ON / OFF (FAX-JX210P)
Enable / disable ECM (Error Correction Mode) when sending a fax. * Select [ON] to send faxes with error correction. If telephone line conditions are poor, the time to send a fax will take longer.
CMS-XML Printing a report on the FAX-JX210P
TX REPORT (Transmission Report) Normally the fax does not print an activity report for transmitting, but you can set the fax to print an activity report every time you send a document. You can set the fax to print an activity report only when an error occurs during transmitting. RX REPORT (Reception Report) Normally the fax does not print an activity report for receiving, but you can set the fax to print an activity report every time you receive a document.
CMS-XML Settings and Activity Reports- FAX-JX210P
Note: Set the volume of the line monitor (sound during dialing). Set the volume of the error alarm sound. Set the volume of the keypad.