| Search Results |
 |
Installing the Camera (VB-H710F / VB-M700F)
|
• Be sure to use a mounting bracket with a mounting screw shorter than 5.5 mm (0.22 in.). Using a mounting bracket with a mounting screw 5.5 mm (0.22 in.) or longer may damage the camera.
|
|
|
How to install (mount) the VB-C300
|
Always use a tripod mounting screw that is less than 5.5 mm (0.22 in.) in length. The use of screws 5.5 mm (0.22 in.) long or longer could damage the camera. Also, the tripod seat used should be at least 30 mm (1.18 in.) in diameter.
|
|
|
Installing the Camera (VB-H41 / VB-M40)
|
The camera can be installed in the upright position. Attach commercial anti-slip guards to the base of the camera and set on a flat, stable surface without inclination, or fix the camera to a tripod, etc. Be sure to use a tripod with mounting screws shorter than 5.5 mm (0.22 in.). Using a tripod with mounting screws 5.5 mm (0.22 in.) or longer may damage the camera.
|
|
|
Operating the Camera in Mobile Camera Viewer
|
( ii ) Position where zooming pauses ... ● Double-tapping the video display area will magnify the video approximately 3 x . ... ● The recorded video cannot be viewed in Mobile Camera Viewer. ... ( ii ) Center Position button
|
|
|
Mobile Camera Viewer - Operating the Camera
|
|
Adjust the focus manually or press the <AF> button on the wireless controller VC-C50i / VC-C50iR
|
If a preset position is restored when the camera is in manual focus mode, the camera may be out of focus once it has moved to the preset position. Adjust the focus manually or press the button on the wireless controller to switch to auto-focus.
|
|
|
Camera Software
|
Camera Operations and Settings Camera operations are performed using the Camera Viewer/ Mobile Camera Viewer. Camera settings are specified from the Setting Page.
|
|
|
Reset the ID correctly or cancel ID mode operation. VC-C50i & VC-C50iR
|
Resetting the ID correctly or cancelling ID mode operation VC-C50i / VC-C50iR When multiple VC-C50i/VC-C50iR cameras are connected and installed, all the cameras in range of the wireless controller simultaneously perform the operations specified. In this situation, the cameras can be operated individually by assigning separate ID numbers to each camera beforehand and then specifying the desired ID number from the wireless controller. This is referred to as ID mode operation.
|
|
|
Operable range of the wireless controller WL-V5 for the VC-C50i and VC-C50iR
|
Operable range of the wireless controller WL-V5 for the VC-C50i and VC-C50iR Use the wireless controller within the range described below, facing it toward the sensor for the wireless controller. The operable range of the wireless controller varies depending on the amount of charge remaining in the batteries and interference from other objects.
|
|
|
Controlling the VC-C50i or VC-C50iR with the WL-V5 Wireless Controller
|
Controlling the VC-C50i or VC-C50iR with the WL-V5 Wireless Controller Contents: What the Buttons on the Wireless Controller do Changing the Camera Head Angle (pan/tilt/home position)
|
|
