| Search Results |
 |
Replace the Ink Tank(s)- BJC-85
|
Installing / Replacing Ink Tanks 4. Select a new ink tank; be sure to use the same type that you removed from the printer. Remove the new ink tank from its package and remove the orange protective cap.
|
|
|
Press the RESUME button to continue. Replace Ink Tank(s) as soon as possible - BJC-85
|
Untitled Document If the low-ink alert has been turned on, the orange ERROR light will flash and tell you which ink tank is low by the number of flashes. You can continue the print job until the ink runs out by pressing the <RESUME> button, but immediate replacement of the ink tank is recommended. Use the printer driver or the printer' s operation panel to reset the low-ink alert after replacing the ink tank.
|
|
|
Disconnect other device and reboot computer
|
Other devices attached to the computer can block proper communication. Check to see if there are any devices (other than USB keyboards or mice) connected to the computer. Disconnect the device( s ) and restart the computer. Once the computer has restarted, attempt your process again.
|
|
|
Fan paper prior to inserting it into the printer to ensure it feeds properly
|
Fan paper prior to inserting it into the printer. Insert the stack of paper back into the tray (print side up for Auto Sheet Feeder, print side down for Cassette). Slide the paper guide( s ) to fit the loaded paper stack. Press <Resume>.
|
|
|
Perform White Level calibration
|
Perform White Level calibration 4. Click the White Level button. 5. Load the white calibration sheet into the printer s sheet feeder (as if you were going to print on it) with the cut corner in the upper left position. 6. Click OK.
|
|
|
BJC-4300 Error Codes - Beeping / Flashing Lights
|
Error Conditions Occurs when the temperature sensor? s (Till) reading on the control board is Irregular.
|
|
