Canon Knowledge Base

Filters

Search Results

Here are some common troubleshooting tips for the LV-X2

Before calling your dealer or service center for assistance , check the following: 1. Make sure you have connected a projector to your computer or video equipment as described in the section "CONNECTING THE PROJECTOR" ... 2. Check cable connection.

How to Connect the SX80 Mk II / SX800 Projector to AV Equipment

Connecting to AV Equipment Connect the projector and AV equipment. Before connecting the cables , turn off the projector and AV equipment.

How to Select an Input Signal Type on the SX80 Mk II / SX800

Types of Input Signals The table below shows the relationship among input signals supported by the projector, input terminals and connection cables . Selecting an Input Signal

How to Set an IP Address when using the SX80 Mk II

Setting IP Address 1 Connect the projector and a computer directly via a cross type LAN cable . 2 Turn on the power of the projector and computer.

Here are the Parts and Controls - Nomenclature for the SX80 Mk II / SX800

Receives a digital content image signal (HDMI). Carries video and audio signals across a single cable .

Connecting to Audio Terminals

Connecting to Audio Terminals Connect an audio cable between the projector and computer if you want to use the projectors speaker

How to Set RS-232C Settings on the WUX10

While the WUX10 does have an RS-232 connection and codes as you mentioned, CITS does not assist in the use of them.

Selecting the Power Management Mode

Selecting the Power Management Mode You can turn on the projector by connecting the power cable without pressing the POWER button Press the OK button to accept your setting and then press the MENU button.

Technical Specifications

AC Power Cord Remote controller and Batteries VGA Cable Lens Cap with String PIN Code Label

How do I Connect the LV-7490 Projector to the Computer

Connecting to a Computer Cables used for connection VGA Cables (Mini D-sub 15 pin) *

Pages [Next]