| Search Results |
 |
Wireless LAN (Wi-Fi) Legal information WUX7500 / WUX6700 / WUX5800
|
FCC/IC NOTICE Model: WUX7500/WUX6700/WUX5800 (including WLAN Module Model CH 9 -1346, FCC ID : AZD221)
|
|
|
How to Set RS-232C Settings on the WUX10
|
While the WUX10 does have an RS -232 connection and codes as you mentioned, CITS does not assist in the use of them.
|
|
|
Projecting Two Images Side by Side WUX7000Z / WUX6600Z / WUX5800Z
|
Press the INPUT button, and then select the input signal for the side with control rights. To determine which side is currently under your control, check the image ID in orange in the upper right of the menu. The side without control rights is labeled with a white circle.
|
|
|
Hazard Distance When Equipped with a Replacement Lens (IEC 62471-5) WUX7000Z / WUX6600Z / WUX5800Z
|
• For assistance when disposing of the projector, contact the Canon Customer Support Center. Do not disassemble the projector yourself when disposing of it.
|
|
|
Technical Specifications
|
Important Information and Quick Start Guide Warranty card AC Power Cord Remote controller and Batteries
|
|
|
Here are some common troubleshooting tips for the LV-X2
|
Before calling your dealer or service center for assistance , check the following: 1. Make sure you have connected a projector to your computer or video equipment as described in the section "CONNECTING THE PROJECTOR"
|
|
|
Menu System settings WUX7500 / WUX6700 / WUX5800
|
Menu screen when the input signal is HDMI Menus that are not available are grayed out or hidden. User screen settings Capture a logo and specify logo display settings. Logo capture Registers the current image as a user logo. Registered user logos can be shown when no signal is received, when the BLANK button is pressed, or as the startup image. Only images at an aspect ratio of 16:10 can be registered as user logos. Logo position Specify the position of registered user logos. You can specify the position after a logo has been registered. Choose from upper left, upper right, center, lower left, or lower right. No signal screen Customize the screen shown when no input signals are received. Screen when blank Select the screen shown when projection is temporarily blanked out by pressing the BLANK button on the remote control. Projector on Select a logo to project after startup until input signals can be projected. On screen Specify display details for on-screen menus, help , and warning or precaution icons. Menu position Reposition menu display. Choose from upper left, upper right, center, lower left, or lower right. Only [Center] is available when edge blending is used. Other display positions are grayed out and not available. Menu display time Extend menu display from the standard 10 or 30 seconds to 3 minutes. The following display times are also changed. Guide Shows the guide screen.
|
|
|
Power Management mode
|
image appears and the countdown begins. After the countdown, the lamp will be off. This function helps to save power consumption and extend the lamp life.
|
|
|
IVIDEO Input - mage Mode Selection
|
This mode helps enhance the image projected on a blackboard. This is mainly effective on a green colored board, not truly effective on a black colored board.
|
|
|
Computer Input - Image Mode Selection
|
For the image projected on a blackboard. This mode helps enhance the image projected on a blackboard. This is mainly effective on a green colored board, not truly effective on a black colored board.
|
|
