Make sure the paper path guide is properly seated

 

Description

Make sure the paper path guide is properly seated

Solution

 

Sometimes a 1303 or 1313 paper jam error can be caused by a misaligned or totally dislodged plastic part used as a paper path guide inside the machine.  Other problems that may occur because of this include the rear cover not closing properly or paper feeding from the cassette but not ejecting. 

If so, the guide needs to be realigned properly in the machine. 

Check the machine as follows:

 

  1. Open the rear cover.

    Slide the rear cover to the left then open it.




    The Normal location of this part is shown in the image below.



     
  2. Remove any paper jam and check for any loose piece of plastic.  The guide is about 5 inches long and is pictured below.  Take note of the
    circled areas.  These are use as a reference for reinstalling the guide






     
  3. If the guide hasn't been dislodged but is mis-seated, push down on the guide to snap it into the correct position.  See picture below.



     
  4. If the guide is laying loose in the machine, reinstall it.

    Image below shows the area where the guide would normally be located. Red circled areas indicate where tabs on guide (see images from step 2) should go




    Position the guide tabs in the slots. The central tab will end up in the center slot (This is indicated by the double-pointed arrow in the photo).



    Push down on the guide to snap into place.




    Finished

 


Doc ID   ART100616
Updated   07/21/2016

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
 
Please provide your comments