How to load the battery in the ELPH LT

Article ID: ART105485 | Date published: 05/11/2015 | Date last updated: 08/15/2015


How to load the battery


Inserting the Battery

Battery: One lithium battery (CR2)

Open the battery cover. While pressing the ridges on the battery cover, lift off the cover.

Insert the battery.

Insert the battery with the + and - terminal positioned correctly with the release tape (A) behind the battery displayed on the LCD

The battery indicator is displayed on the LCD panel

Close the battery cover.
  • Be careful not to trap the release tape when closing the battery cover

If -- -- -- blinks in the LD panel, after you change the battery you will need to reset the date to the correct date and time

Removing the battery
  • Slowly pull the end of the release tape to remove the battery


After removing the battery to replace it, do not touch any of the switches on the camera. This will allow the date and time to be retained for approximately five seconds



Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments