Confirm the Ink Cartridges are installed correctly - iP2700 / iP2702
Article ID: ART105682 | Date published: 05/11/2015 | Date last updated: 08/15/2015
 

Solution

Install the Ink Cartridges Properly

  1. Open the Front Cover (A).



    Important:

    -When opening the Front Cover, the Cartridge Holder moves automatically.

    -If the Cartridge Holder does not move, make sure that the printer is turned on.

    -If the Front Cover is left open for more than 10 minutes, the Cartridge Holder moves to the right. In this case, close and reopen the Front Cover.

  2. Make sure that the Cartridge Holder (D) moves to the installation position.



  3. Follow the next procedure to insert the Black and Color Cartridges into their corresponding slots and .



  4. Open the Ink Cartridge Locking Cover on the right side.



    Pinch (E) firmly and pull up the cover.

  5. Remove the Black Cartridge from its package.



    Important:

    Handle the Cartridges carefully. Do not drop or apply excessive pressure to them.

    Be sure to use the supplied Cartridges.

    Be careful not to stain your hands or surrounding work area with ink on the removed protective tape.

    Do not touch the electrical contacts (G) or print head nozzles (H) on a Cartridge. The printer may not print properly if you touch them.

  6. Pull the orange protective tape (F) in the direction of the arrow and remove it carefully.

  7. Place the Black Cartridge into the right slot .



    Important:

    -Do not knock the Cartridge against the sides of the holder.

    -Install the Black Cartridge into the right slot , and the Color Cartridge into the left slot .

  8. Push down of the Ink Cartridge Locking Cover until you hear a click to close it completely.



    View the Ink Cartridge Locking Cover straight on and check that it is locked correctly (not at an angle).

  9. Insert the Color Cartridge into the left Cartridge Holder in the same way as the Black Cartridge.



  10. Close the Front Cover.



  11. Wait until the POWER lamp (green) (I) stops flashing and stays lit, and proceed to the next step.



    It takes about 2 minutes until the POWER lamp stops flashing and stays lit.

Important:

  • Once you have installed the Cartridges, do not remove them unnecessarily.
  • If the Alarm lamp (J) flashes orange, make sure that the Cartridges are correctly installed.

SIMS Doc Id

0