Setting Continuous Shooting mode PowerShot SD3500 IS.
Article ID: ART107383 | Date published: 05/11/2015 | Date last updated: 08/15/2015
 

Solution

Continuous Shooting

In this mode, the camera shoots continuously while the shutter button is held down. Recording ceases when the shutter button is released. In addition, under the following conditions, continuous shooting can occur at a consistent interval until the SD card is full*.

  • The recommended SDC-512MSH SD card (sold separately) is used and formatted with a low level format.
    * This figure reflects standard shooting criteria established by Canon. Actual figures may vary according to the subject and shooting conditions.
    * If continuous shooting suddenly stops, the SD card may be full.

To set Continuous Shooting

  1. Press the <FUNC./SET> button and use the or to choose , then press the button.
  2. Next, use the or to choose then press the <FUNC./SET> button.


  3. Shoot the image.

    The camera will continue to record successive images while the shutter button is fully pressed. Recording will cease when the shutter button is released, the card is full or the card does not support a write speed to allow continuous shooting to continue.
To enhance the continuous shooting performance when you suspect the speed has dropped, you are recommended to format the SD card in the camera (Low Level Format) after you save all its images to your computer.
  • The interval between shots may lengthen slightly when the camera's built-in memory fills.
  • If the flash is firing, the interval between shots will lengthen to accommodate the flash's charging requirements.

SIMS Doc Id

0