Setting the Wireless LAN Using WPS

Switching the Connection Method to Wireless LAN

1. Press [ ] (Menu).

2. Select <Network Settings> with [ ] or [ ], and then press [OK].

The screen below is displayed for approximately 5 seconds. (You do not need to turn the machine OFF/ON in this step.)

3. Select <Select Wired/Wireless LAN> using [ ] or [ ], and then press [OK].

4. Select <Wireless LAN> using [ ] or [ ], and then press [OK].

5. Turns the machine OFF/ON when the following screen disappears.

It is necessary to turn the machine OFF/ON to activate the settings.

Turn OFF the machine and wait for at least 10 seconds before turning it back ON.

MF8380Cdw

MF8080Cw

Setting the Machine Using WPS (Push Button Mode)

Press the WPS button on your wireless LAN routers and/or access points for connection.

1. Press [ ] (Menu).

2. Select <Network Settings> using [ ] or [ ], and then press [OK].

When the system manager ID and system manager PIN are specified, use the numeric keys to enter the ID and number, and then press [ ] (Log In/Out).

3. Select <Wireless LAN Settings> using [ ] or [ ], and then press [OK].

4. Press [OK].

5. Select <WPS Push Button Mode> using [ ] or [ ], and then press [OK].

6. Select <Yes> using [ ], and then press [OK].

7. Within two minutes, press and hold the WPS button on the wireless LAN router or access point for approximately 5 seconds.

* If "Cannot find Access Point" appears, press [OK] to close the screen and follow the procedure again from Step 5.

8. Make sure the Wi-Fi indicator blinks.

When the wireless LAN router or access point is detected, the Wi-Fi indicator blinks.

The screen below is displayed for approximately 2 seconds, and then the Wi-Fi indicator lights up.

* If an error message appears, press [OK] to close the screen and follow the procedure again from Step 5. If you cannot detect the access point after retrying, see "."

9. Wait until the machine sets the IP address automatically (approx. 2 min).

If you want to set the IP address manually, see in the e-Manual.

Checking the Wireless LAN Setting is Completed

1. Press [ ] (Status Monitor/Cancel).

2. Select <Network Information> using [ ] or [ ], and then press [OK].

3. Select your network type.

To check the IPv4 address settings

• Select <IPv4> using [ ] or [ ], and then press [OK].

• Select the setting to check using [ ] or [ ], and then press [OK].

To check the IPv6 address settings

• Select <IPv6> using [ ] or [ ], and then press [OK].

• Select the setting to check using [ ] or [ ], and then press [OK].

4. Take note of the IP address.

IPv4

IPv6

5. Press [ ] (Status Monitor/Cancel) to close the screen.

6. Start the Web browser of a computer which is connected to a network.

7. Enter "http://IP address of the machine/" in the address field and press the [ENTER] key on the keyboard.

The <IP address of the machine> is the address noted in step 4 above.

Example: http://192.168.0.215/

8. Check that the screen of the Remote UI is displayed.