Getting started with your new camera (PowerShot SX520 HS)
Article ID: ART116559 | | | Date published: 05/12/2015 | | | Date last updated: 08/15/2015 |
Description
Getting started with your new camera (PowerShot SX520 HS)
Solution
Getting started with your new camera (PowerShot SX520 HS) ID
:
8202117100
_
EN
_
1
|
|
Solution |
Follow the below steps to get started with your new camera.
Charging the Battery Pack Before use, charge the battery pack with the included charger. Be sure to charge the battery pack initially, because the camera is not sold with the battery pack charged.
1. After aligning the
![]() ![]() ![]()
2. Charge the battery pack.
CB-2LY: Flip out the plug (
![]() ![]() ![]()
CB-2LYE: Plug the power cord into the charger, then plug the other end into a power outlet.
![]()
3. After unplugging the battery charger, remove the battery pack by pushing it in (
![]() ![]()
Inserting the Battery Pack and Memory Card Insert the included battery pack and a memory card (sold separately).
1. Open the cover
Slide the cover
![]() ![]() ![]()
2. Insert the battery pack.
Holding the battery pack with the terminals
![]() ![]() If you insert the battery pack facing the wrong way, it cannot be locked into the correct position. Always confirm that the battery pack is facing the right way and locks when inserted.
![]()
3. Check the cards write-protect tab and insert the memory card.
Recording is not possible on memory cards with a write-protect tab when the tab is in the locked position. Slide the tab to the unlocked position.
Insert the memory card with the label
![]() Make sure the memory card is facing the right way when you insert it. Inserting memory cards facing the wrong way may damage the camera.
![]()
4. Close the cover.
Lower the cover
![]() ![]() ![]() Setting the Date and Time Set the current date and time correctly as follows if the [Date/Time] screen is displayed when you turn the camera on. Information you specify this way is recorded in image properties when you shoot, and it is used when you manage images by shooting date or print images showing the date. You can also add a date stamp to shots, if you wish
1. Press the <Power> button to turn the camera on.
2. Set the date and time.
![]() ![]()
3. When finished, press the <FUNC./SET> (
![]()
4. Specify your home time zone.
Press the <
![]() ![]() ![]()
5. Press the <FUNC./SET> (
![]() Shooting 1. Set the mode dial to <
![]() ![]()
![]()
2. Compose the shot.
To zoom in and enlarge the subject, move the zoom lever toward <
![]() ![]() ![]()
3. Focus.
![]() ![]()
![]()
5. Press the shutter button all the way down.
![]()
This concludes the guide to getting started with your new camera.
|
SIMS Doc Id
8202117100