Wireless LAN connection of your printer to an access point using the WPS Push Button Method - iP110

Article ID: ART116829 | Date published: 05/12/2015 | Date last updated: 05/15/2019


This article explains how you can connect the PIXMA iP110 to your wireless network using the WPS Push Button method.



Wireless Setup Using WPS (Wi-Fi Protected Setup)

Before Starting Wireless Connection Setup

  • Make sure that the printer is turned on.


  1. Make sure that the button on the access point is ready to be pressed.
  2. Hold down the Wi-Fi button (A) on the printer until the POWER lamp (B) flashes once, then release the Wi-Fi button after the flash.

  3. Make sure that the Wi-Fi lamp (C) is flashing quickly and the POWER lamp is lit as seen in the diagram below, and then, within 90 seconds, hold down the button on the access point for a few seconds.

  4. Make sure that the Wi-Fi lamp and the POWER lamp are lit.



The wireless LAN setup using WPS is completed.
Install the software.

-> [ How to install the software from the Setup CD or from the Setup & Manual site (wireless LAN connection) ]

If the Alarm lamp lights up

  • When the Wi-Fi lamp flashes slowly and the Alarm lamp is lit

    After checking the below points, wait for a while and configure wireless connection setting again.​
    • Press the button on only one access point.
    • Check the security settings of the access point.


  • When the Wi-Fi lamp flashes quickly and the Alarm lamp is lit.

    Is the network device (router, etc.) turned on? If the network device is already turned on, turn it off, then turn it back on.
  • If the Alarm lamp still lights up​
    • Are the computer and network device configured?
    • Are the access point and printer installed in an open space where wireless communications are possible?
    • Is the access point operating in IEEE802.11n (2.4 GHz), IEEE802.11g or IEEE802.11b?




Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments