Setting the Flash (On) (PowerShot SX600 HS / PowerShot SX610 HS)
| Article ID: ART117352 |
| |
Date published: 05/12/2015 |
| |
Date last updated: 08/15/2015 |
Description
Setting the Flash (On) (PowerShot SX600 HS / PowerShot SX610 HS)
Solution
| Setting the Flash (On) (PowerShot SX600 HS / PowerShot SX610 HS) ID
:
8201997500
_
EN
_
3
|
| Solution |
When setting [Flash] to [Auto], [Flash] is not activated if the surroundings are light. However, when shooting with the subject backlit, [Flash] is sometimes used not to make the subject dark. This section describes the setting to shoot with constant flash.
IMPORTANT
- The following explanations are provided based on the assumption that the [Shooting Mode] is set to [Program AE] (
 ).
1. Press the <Power> button to turn the camera on.
Move the <Flash> (  ) switch to raise the flash.
2. Press the <Flash> (  ) button.
3. Press the [  ], [  ] buttons to select [On] (  ).
4. If the following icon is displayed on the monitor, the setting is complete.
IMPORTANT
- The setting screen cannot be accessed by pressing the <Flash> () buttonwhen the flash is lowered. Move the <Flash> () switch to raise the flash,then configure the setting.
- <Flash> cannot be set to [On] in the following modes:
[Hybrid Auto] (  ), [Creative Shot] (  ), [Auto] (  ), [High-Speed burst] (  ), [Low Light] (  ), [Fireworks] (  )
|
