550EX Speedlite :How to setup wireless manual flash with varied flash output.
Article ID: ART118403 | Date published: 05/12/2015 | Date last updated: 11/29/2017
 

Description

How to setup wireless manual flash with varied flash output.

Solution

You can set a different output for each receiver unit (A, B and C) as follows.
1. On the sender unit, press the <MODE> button and select M

2. Press the <SEL/SET> button and select <RATIO)

  • Pressing the <SEL/SET> button changes the selection in the following loop:

3. Press the <-> button to select RATIO ON A:B or A:B:C

  • RATIO ON A:B or A:B:C will blink

4. Press the <SEL/SET> button

  • A and the flash output display will blink

5. Press the <+> or <-> button to set the flash output for A

6. Press the <SET/SEL> button

  • B and the flash output display will blink

7. Press the <+> or <-> button to set the flash output for B

8. Press the <SEL/SET> button

  • C and the flash output display will blink

9. Press the <+> or <-> button to set the flash output for C

10. Press the <SEL/SET> button to register the settings

 

  • If there are only two receiver units (A and B), steps 9 and 10 may be omitted
  • After you complete the settings, you can check the respective flash output for receiver units A, B and C pre pressing the <+> or <-> button
  • Press the sender unit's lamp to test fire the receiver units

SIMS Doc Id

0