Load paper correctly - iP3500
Article ID: ART120220 | Date published: 05/12/2015 | Date last updated: 08/17/2015
 

Solution

Untitled Document

Loading Paper

You can load paper in the Front Tray and the Rear Tray.


How to load paper in the Rear Tray

1. Fan paper and align four corners.

2. When loading paper, follow the instruction below carefully.

<1> Open the sheet feeder cover and pull out the paper support.

<2> Load paper with the paper's print side facing up, aligning its right edge to the cover guide.

Note: Setting Credit Card sized paper with the long-side down by mistake may cause paper jam.

<3> Pinch and slide the paper guide to the paper's left side.

<4> Open the front feeder.

<5> Extend the output paper support.

Note: When loading legal sized paper, make sure to close the stopper of the output paper support.

<6> Switch the paper thickness lever according to the type of paper you use.
- Left: When printing on the paper other than envelopes or T-shirt transfers.
- Right: When printing on envelopes or T-shirt transfers.

<7> Ensure that the Power lamp is lit.

3. When loading envelopes, be sure the flap is closed and to the left with the non-flap side of the envelope facing up.


top of page



How to load paper in the Front Tray

Important:
Only 8.5" x 11" (Letter size), A4 and B5 plain paper can be used in the front feeder

1. Fan paper and align four corners.

Note: Before loading paper, be sure to flatten its four corners. Otherwise, the paper may jam. When paper is curled, hold the opposing curled corners and gently bend them in the opposite direction until the paper becomes completely flat.

2. Before loading paper, do the following.

<1> Open the front feeder.

<2> Extend the output paper support, then its stopper.

3. When loading paper, follow the instruction below with care.

<3> Load paper with the paper's print side facing down, aligning its right edge to the right edge of the front feeder.

Note: Do not load paper in the paper output tray.

<4> Align the trailing edge of the paper to one of the paper size marks on the front feeder.

<5> Pinch and slide the paper guide to the paper's left side.

Note: Do not load paper higher than the load limit mark.

<6> Set the paper thickness lever to the left.

<7> Turn on the printer and confirm that the Power lamp is lit.

top of page






SIMS Doc Id

0