Installing or replacing the backup battery Elura 100

Article ID: ART127480 | Date published: 05/12/2015 | Date last updated: 08/14/2015


Installing or replacing the backup battery Elura 100


Installing or replacing the backup battery Elura 100

The backup battery (lithium button battery CR1616) allows the camcorder to retain date, time and other camcorder settings while the power source is disconnected. Connect a power source to the camcorder when replacing the backup battery to retain the settings.

  1. Open the memory slot/backup battery compartment cover.
  2. Pull out the backup battery holder using a flat screwdriver or a similar tool.

  3. Insert the backup battery in the holder with the + side facing down.

  4. Insert the battery holder and push it in until it clicks, then close the cover.
  • The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble, heat above 212 °F (100 °C) or incinerate the battery.
  • Replace the battery with a CR1616 made by Panasonic, Hitachi Maxell, Sony, Toshiba, Varta or Renata. Use of other batteries may present a risk of fire or explosion.

  • Do not pick up the battery using tweezers or other metal tools as this will cause a short circuit.
  • Wipe the battery with a clean dry cloth to ensure proper contact.
  • Keep the battery out of reach of children. If it is swallowed, seek medical assistance immediately. The battery case may break and the battery fluids may damage stomach and intestines.
  • Do not disassemble, heat or immerse the battery in water to avoid the risk of explosion.

The backup battery has a life span of about a year. flashes in red to inform you that it needs to be replaced.



Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments