Remote Switch and Remote Controller
You can use Remote Switch RS-60E3 or Timer Remote Controller RC-1/RC-5 ( sold separately) to the camera and shoot with it.
note:
To operate the accessory, refer to its instruction manual.
Connecting the Remote Switch
1. Open the terminal cover.
2. Connect the plug to the remote control terminal.
reference:
To disconnect the plug, grasp the plug's silver part and pull out.
Remote Control Shooting
Remote controllers to shoot wirelessly up to about 5 meters/16.4 feet from the camera. The RC-1 can trip the shutter immediately or after a 2-sec. delay, and the RC-5 trips the shutter after a 2-sec. delay.
1. Set the power switch to <ON>.
2. When the camera is ready to shoot, Press the <Drive mode selection> ( ) button.
3. Press the <Cross Keys> to select the [Self-timer/Remote control], then press the <SET> button.
4. Point the remote controller toward the camera's remote control sensor and press the transmit button.
5. The camera will autofocus. When focus is achieved, the self-timer lamp will light and the picture will be taken.
Attention:
Camera misoperation may occur near certain types of fluorescent lights. During wireless remote control, try to keep the camera away from fluorescent light.