Setting RX Reports to Print Automatically (MF4370dn/MF4350d/D480 Only)
Article ID: ART129150 | Date published: 05/12/2015 | Date last updated: 08/17/2015


Setting RX Reports to Print Automatically (MF4370dn/MF4350d/D480 Only)


Setting RX Reports to Print Automatically

This section describes how to set RX reports to print automatically.

The default setting is <OUTPUT NO>.

The following items are printed in an RX Report:

JOB NO.: Job number

MODE: Mode of transaction (G3 or ECM)

NO.: Sequence number

DESTINATION TEL/ID: Number of the sending machine (displayed only if registered in their machine)

START TIME: Date and time of transaction

PAGE: Number of pages received

RESULT: Result of transaction

  • OK: Reception successful
  • NG: Reception failed
  • STOP: Reception manually canceled before completion
  • MEM.FULL: Memory became full during reception.

1. Press [Menu].

2. Press [ ] or [ ] to select <REPORT SETTINGS>, then press [OK].

3. Press [ ] or [ ] to select <RX REPORT>, then press [OK].

4. Press [ ] or [ ] to select the setting you want, then press [OK].

  • <OUTPUT NO>: Does not print a report.
  • <OUTPUT YES>: Prints a report every time you receive a document.
  • <PRINT ERROR ONLY>: Prints a report only when a reception error occurs.

5. Press [Stop/Reset] to return to the standby mode.